Maintenance methods and precautions for vertical cutting machines
1、 Maintenance methods
After each use, the surface of the vertical cutting machine should be promptly cleaned of dust, sponge debris, oil stains, and other debris. You can use a clean cloth or compressed air for cleaning.
Regularly clean the interior of the equipment, especially the cutting area and transmission components, to prevent the accumulation of debris from affecting equipment performance.
Lubrication and maintenance
According to the equipment manual, regularly lubricate the lubrication points of the cutting machine. Common lubrication parts include guide rails, lead screws, gears, etc.
Choose appropriate lubricating oil or grease to ensure its quality meets equipment requirements, in order to reduce wear and extend equipment life.
Tool maintenance
Regularly check the wear of cutting tools, and replace them promptly if severe wear is found.
To maintain the sharpness of the tool, it can be sharpened regularly or processed using a tool grinding device.
Be careful when installing and disassembling cutting tools to avoid damaging the tools and equipment.
Electrical system maintenance
Regularly check whether the wiring of electrical equipment is loose and whether the contact is good. If there are any problems, they should be dealt with in a timely manner to prevent electrical faults.
Clean the dust and debris on the surface of electrical equipment to maintain good heat dissipation.
Check the insulation performance of electrical equipment to ensure safety and reliability.
Regular inspection and maintenance
Regularly inspect the cutting machine, including mechanical structure, electrical system, hydraulic system (if any), etc. Timely identify and eliminate potential faults and hazards.
Check the accuracy and performance of the equipment, such as cutting size accuracy, cutting surface quality, etc. If there are any problems, they should be adjusted and repaired in a timely manner.
2、 Precautions
Safe operation
Operators must undergo training and be familiar with the operating methods and safety precautions of the vertical cutting machine.
When operating equipment, strictly follow the operating procedures and do not operate in violation of regulations.
Wear personal protective equipment such as helmets, safety shoes, gloves, etc. to prevent accidents.
Tool installation and replacement
When installing cutting tools, ensure that they are securely installed without any looseness.
When replacing cutting tools, first turn off the equipment power and wait for the equipment to completely stop running before proceeding with the operation.
The selection of cutting tools should be based on the properties and requirements of the cutting material, and unsuitable tools should not be used.
Equipment maintenance and upkeep
Regularly maintain and upkeep the cutting machine without delay or neglect.
When carrying out equipment maintenance, the power supply of the equipment should be turned off first, and warning signs such as "Do not close" should be hung.
Maintenance and upkeep work should be carried out by dedicated personnel, and unauthorized repairs and adjustments are not allowed.
Working environment
The vertical cutting machine should be placed in a dry and well ventilated environment, avoiding direct sunlight and humid conditions.
The work area should be kept clean and no debris should be piled up to ensure the safety of operators and the normal operation of equipment.
Fault handling
When the vertical cutting machine malfunctions, the equipment should be stopped immediately and inspected and repaired.
Unauthorized disassembly of equipment or illegal repairs are not allowed, and dedicated maintenance personnel should be promptly contacted for handling.
Before troubleshooting, do not forcefully use the equipment to avoid causing greater damage.
